Use the best ways of preparing for 350-401 Exam Dumps with Lead1Pass Cisco 350-401 dump PDF [2024]
Cisco 350-401 exam candidates will surely pass the Exam if they consider the 350-401 dumps learning material presented by Lead1Pass.
NEW QUESTION # 270
Refer to the exhibit.
An engineer is troubleshooting a connectivity issue and executes a traceoute. What does the result confirm?
- A. The destination server reported it is too busy
- B. The protocol is unreachable
- C. The probe timed out
- D. The destination port is unreachable
Answer: C
Explanation:
In Cisco routers, the codes for a traceroute command reply are:
! - success* - time outN - network unreachableH - host unreachableP - protocol unreachableA - admin deniedQ - source quench received (congestion)? - unknown (any other ICMP message)In Cisco routers, the codes for a traceroute command reply are:
! - success* - time outN - network unreachableH - host unreachableP - protocol unreachableA - admin deniedQ - source quench received (congestion)? - unknown (any other ICMP message)
NEW QUESTION # 271
Drag and drop the tools from the left onto the agent types on the right.
Answer:
Explanation:
NEW QUESTION # 272
Refer to the exhibit.
An engineer reconfigures the pot-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log.
Which command set resolves this error?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION # 273
Which LISP component is required for a LISP site to communicate with a non-LISP site?
- A. Proxy ETR
- B. ETR
- C. Proxy ITR
- D. ITR
Answer: A
NEW QUESTION # 274
Which IP SLA operation requires the IP SLA responder to be configured on the remote end?
- A. ICMP echo
- B. ICMP jitter
- C. UDP jitter
- D. TCP connect
Answer: C
Explanation:
The IP SLA operation that requires an IP SLA responder to be configured on the remote end is UDP jitter.
This operation measures the delay variation (jitter) between IP SLA devices and requires a responder to accurately measure this metric. The responder provides a timestamp for when the packet is received and sent back, allowing for precise measurement of round-trip time and jitter3.
References: IP SLAs Configuration Guide, Cisco IOS Release 15M&T3.
NEW QUESTION # 275
Refer to the exhibit.
An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)
B)
C)
D)
- A. Option B
- B. Option D
- C. Option C
- D. Option A
Answer: A
NEW QUESTION # 276
Refer to the exhibit.
Which Python code snippet prints the descriptions of disabled interfaces only?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION # 277
Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option C
- D. Option B
Answer: A
NEW QUESTION # 278
Refer to the exhibit.
An engineer configures routing between all routers and must build a configuration to connect R1 to R3 via a GRE tunnel Which configuration must be applied?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION # 279
Which HTTP code must be returned to prevent the script form exiting?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 280
What is a capability of the Cisco DNA Center southbound API?
- A. It allows administrators to make API calls to Cisco DNA Center.
- B. It adds support for managing non-Cisco devices from Cisco DNA Center.
- C. It connects to ITSM services such as ServiceNow.
- D. It sends webhooks from Cisco DNA Center when alerts are triggered.
Answer: B
NEW QUESTION # 281
Refer to the exhibit.
R1 has a BGP neighborship with a directly connected router on interface Gi0/0.
Which command set is applied between the iterations of show ip bgp 2.2.2.2?
- A. R1(config)#no ip route 192.168.50.2 255.255.255.255 Gi0/0
- B. R1(config)#router bgp 65001
R1(config-router)#neighbor 192.168.50.2 shutdown - C. R1(config)#ip route 2.2.2.2 255.255.255.255 192.168.50.2
- D. R1(config)#router bgp 65002
R1(config-router)#neighbor 192.168.50.2 shutdown
Answer: C
NEW QUESTION # 282
Refer to the exhibit. What is output by this code?
- A. 0 1 2 3 4
- B. 0 1 2 3 4 5
- C. 0 5
- D. (0,5)
Answer: A
NEW QUESTION # 283
Refer the exhibit.
Which configuration elects SW4 as the root bridge for VLAN 1 and puts G0/2 on SW2 into a blocking state?
A)
B)
C)
D)
- A. Option B
- B. Option D
- C. Option C
- D. Option A
Answer: A
NEW QUESTION # 284
Which line must be added in the Python function to return the JSON object {"cat_9k": "FXS193202SE")?
- A. Option D
- B. Option C
- C. Option B
- D. Option A
Answer: A
NEW QUESTION # 285
Drag and drop the characteristics from the left onto the infrastructure types on the right.
Answer:
Explanation:
Explanation
NEW QUESTION # 286
Drag and Drop Question
Drag and drop the characteristics from the left onto the orchestration tools that they describe on the right.
Answer:
Explanation:
NEW QUESTION # 287
Refer to the exhibit.
A network engineer configures OSPF and reviews the router configuration. Which interface or interface or interface are able to establish OSPF adjacency?
- A. Gigabit Ethernet0/0 and GigabitEthemet0/1
- B. only GigabttEthernet0/0
- C. GigabitEthemet0/1 and GigabitEthernet0/1.40
- D. only GigabitEthernet0/1
Answer: D
Explanation:
OSPF adjacency can only be established on the GigabitEthernet0/1 interface. In the router configuration, OSPF is enabled on GigabitEthernet0/1, as indicated by the line protocol being up. The other interfaces, including GigabitEthernet0/0 and GigabitEthernet0/1.40, cannot establish OSPF adjacency due to reasons such as area mismatch or network type discrepancies. References := Implementing and Operating Cisco Service Provider Network Core Technologies
NEW QUESTION # 288
Which technology enables a redundant supervisor engine to take over when the primary supervisor engine fails?
- A. FHRP
- B. SSO
- C. graceful restart
- D. NSF
Answer: B
Explanation:
SSO is the base technology that has this capability at L-2. NSF sits on top of SSO to extend the same capability to L-3.
NEW QUESTION # 289
Drag and drop the snippets onto the blanks within the code to construct a script that advertises the network prefix 192.168.5.0/24 into a BGP session. Not all options are used
Answer:
Explanation:
NEW QUESTION # 290
Drag and drop the characteristics from the left onto the correct infrastructure deployment types on the right.
Answer:
Explanation:
Explanation
On premise: customizable,specific requirements,resources
Cloud: scale, built-in automated backup, strong stable internet
NEW QUESTION # 291
......
Full 350-401 Practice Test and 981 unique questions with explanations waiting just for you, get it now: https://drive.google.com/open?id=1tMBcLTGwI8ZNZWPPtUe7RD3GHEeH_xQj
Accurate & Verified Answers As Seen in the Real Exam here: https://www.lead1pass.com/Cisco/350-401-practice-exam-dumps.html