100% Free F5 Networks Certification Study Materials 201 Dumps PDF Demo Cert Guide Cover
PDF Exam Material 2024 Realistic 201 Dumps Questions
NEW QUESTION # 125
Refer to the exhibit.
How are new connections load balanced?
- A. To the pool member with a high priority group value defined
- B. To the pool member with the least number of connections
- C. To the pool member with a low priority group value defined
- D. To the first two members listed with the same priority group
Answer: B
NEW QUESTION # 126
Refer to the exhibit.
Which Pool Members are receiving traffic?
- A. serv1
- B. Serv1, serv2,serv3, serv4
- C. serv1, serv3, serv4
- D. serv1, serv3
Answer: C
NEW QUESTION # 127
A BIG-IP Administrator has configured a BIG-IP cluster with remote user authentication against dcOl f5trn.com. Only local users can successfully log into the system. Configsync is also failing.
Which two tools should the 8IG-IP Administrator use to further investigate these issues? (Choose two)
- A. pam_timestamp_check
- B. pwck
- C. dig
- D. passwd
- E. ntpq
Answer: D,E
NEW QUESTION # 128
Which three iRule events are likely to be seen in iRules designed to select a pool for load balancing? (Choose three.)
- A. SERVER_CONNECTED
- B. HTTP_RESPONSE
- C. HTTP_REQUEST
- D. SERVER_SELECTED
- E. CLIENT_ACCEPTED
- F. CLIENT_DATA
- G. SERVER_DATA
Answer: C,E,F
NEW QUESTION # 129
A custom HTTP monitor is failing to a pool member 10.10.3.75:8080 that serves up www.example.com.
A ping works to the pool member address.
The SEND string that the monitor is using is: GET/HTTP/l.l/r/n/Host.www.example.com/r/n/Connection Close/r/n/r/n Which CLI tool syntax will show that the web server returns the correct HTTP response?
- A. tracepath 'http://www.example.com:80
- B. curl-header 'Host:www.example.com'
http://10.10.3.75:8080/ - C. curlhttp://10.10.10.3.75:8080/www.example.com/index.html
- D. tracepath 10.10.3.75:8080 GET /index
Answer: B
NEW QUESTION # 130
You have created a custom profile named TEST2. The parent profile of TEST2 is named TEST1. If additional changes are made to TEST1, what is the effect on TEST2?
- A. Changes to TEST1 cannot affect TEST2 once TEST2 is saved.
- B. When TEST1 is changed, the administrator is prompted and can choose whether to propagate changes to TEST2.
- C. Some of the changes to TEST1 may propagate to TEST2.
- D. All changes to TEST1 are propagated to TEST2.
Answer: C
NEW QUESTION # 131
Which two statements
describe differences
between the active and standby systems. (Choose two.)
- A. Configuration changes can only be made on the active system.
- B. Monitors are performed only by the active system.
- C. FailElover triggers only cause changes on the active system.
- D. Floating selfElIP addresses are hosted only by the active system.
- E. Virtual server addresses are hosted only by the active system.
Answer: D,E
NEW QUESTION # 132
Refer to the exhibit.
A BIG-IP Administrator configures a Virtual Server to handle HTTPS traffic. Users report that the application is NOT working.
Which actional configuration is regard to resolve this issue?
- A. Configure SSL Profile (Server)
- B. Configure Protocol Profile (Server)
- C. Configure Service Profile HTTP
- D. Configure SSL Profile (Client)
Answer: D
NEW QUESTION # 133
When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)
- A. the port lockdown settings for the SCCP
- B. the netmask of the host via the management port
- C. the netmask of the SCCP
- D. the IP address of the host via the management port
- E. the IP address of the SCCP
- F. the port lockdown settings for the host via the management port
Answer: B,D
NEW QUESTION # 134
When using the setup utility to configure a redundant pair, you are asked to provide a "Failover Peer IP". Which address is this.
- A. an address of the other system in a redundant pair configuration
- B. an address of the other system in its management network
- C. an address on the current system used to listen for failElover messages from the partner BIGIP
- D. an address on the current
system used to
initiate mirroring
and network failElover heartbeat messages
Answer: A
NEW QUESTION # 135
A user wants to use the iHealth Upgrade Advisor to determine any issues with upgrading TMOS from 13.0 to 13.1.
Where can the user generate the QKView to upload to iHealth?
- A. System > Support
- B. System > Software Management
- C. System > Configuration
- D. System > Archives
Answer: A
NEW QUESTION # 136
Refer to the exhibit.
Which two pool members are eligible to receive new connections? (Choose two)
- A. 10.21.0.102.80
- B. 10.21.0.101.80
- C. 10.21.0.103.80
- D. 10.21.0.104.80
- E. 10.21.0.105.80
Answer: B,D
NEW QUESTION # 137
Assuming other failElover settings are at their default state, what would occur if the failElover cable were to be disconnected for five seconds and then reconnected.
- A. Nothing. FailElover due to loss of voltage will not occur if the voltage is lost for less than ten seconds.
- B. When the cable is disconnected, both systems will become active. When the voltage is restored, both systems will maintain active mode.
- C. When the cable is disconnected, both systems will become active. When the voltage is restored, unit two will revert to standby mode.
- D. As long as network communication is not lost, no change will occur.
Answer: C
NEW QUESTION # 138
Refer to the exhibit.
Which two pool members should be chosen for a new connection? (Choose two.)
- A. 172.16.15.4.80
- B. 172.16.15.9.80
- C. 172.16.15.7.80
- D. 172.10.15.2.80
- E. 172.16.15.1.80
Answer: A,C
NEW QUESTION # 139
A BIG-IP Administrator needs to configure the BIG-IP system to perform load balancing for FTP servers running passive mode FTP.
How should the administrator configure the Virtual Server to perform this load balancing?
- A. A Performance Layer 4 Virtual Server + FTP profile
- B. A Standard Virtual Server + FTP profile
- C. A Forwarding Virtual Server
- D. A Message Routing Virtual Server
Answer: B
NEW QUESTION # 140
......
The F5 201 exam consists of multiple-choice questions, and candidates are required to complete it within two hours. The questions are designed to test the candidate's understanding of various concepts related to BIG-IP administration, including system setup and configuration, network and application services, security, and troubleshooting. 201 exam is challenging, and candidates are advised to prepare thoroughly using study materials and practice tests.
F5 201 (BIG-IP Administrator) Certification Exam is a vendor-neutral certification exam and is recognized by IT organizations worldwide. BIG-IP Administrator Exam certification exam is designed to provide IT professionals with the knowledge and skills needed to design, deploy, and manage F5 BIG-IP systems in complex enterprise environments. BIG-IP Administrator Exam certification exam is also designed to provide IT professionals with the knowledge and skills needed to troubleshoot and optimize F5 BIG-IP systems for maximum performance and availability.
Updated F5 201 Dumps – PDF & Online Engine: https://www.lead1pass.com/F5/201-practice-exam-dumps.html
201.pdf - Questions Answers PDF Sample Questions Reliable: https://drive.google.com/open?id=1yhsFsIGDJJIYZJAQ7uSg0s18i4P5uAeT